R.H. Peterson G4-16P Owner's Manual download pdf (Page 5)

L-A2-102

Rev 8 - 1501081400

This safety pilot system must be installed by a qualiﬁ ed professional service technician. Instructions

must be followed carefully when installing to ensure proper performance and full beneﬁ t from the

burner system and safety pilot system.

These instructions must be used as a supplement to the instructions supplied with the R.H. Peterson burner

system. Follow the burner system instructions and make adjustments as appropriate for the addition of a

safety pilot system. Use gas pipe sealing compound that is resistant to all gasses (or Teﬂ on tape) and apply

to all male pipe connections. DO NOT apply pipe sealing compound to any ﬂ are connections. Make sure that

all connections are tight.

The valve system is shipped pre-assembled for easy

installation onto the burner pan.

Note: Installation is easier when done outside of the

ﬁ replace.

PREPARATION

If the burner that the valve system is to be added to is

already installed; remove all decorative media, set aside to

be reinstalled later, and disconnect the ﬂ ex connector and

adapter from the burner pan (using the instructions that

came with the original burner).

INSTALL VALVE

1. Apply gas pipe sealing compound (or Teﬂ on tape) to the

male end of the fuel injector or air mixer on the burner.

2. Install the valve to the fuel injector or air mixer by

screwing the pan into the valve (Fig. 5-1). Take care not

to damage the attached pilot assembly when rotating the

burner pan. Be sure all connections are tight, however

do not overtighten to prevent damage to the valve.

INSTALL FLAME DIVERTER BRACKET

For installation on G4/G45 burners only. When properly

installed onto the burner pan, the ﬂ ame diverter bracket

will promote quicker ignition and protect the safety control

system from overheating.

Note: You must ﬁ rst install the ﬂ ame diverter bracket

before installing the pilot/igniter assembly.

1. Place the ﬂ ame diverter bracket over the side edge

of the burner pan, near the location the safety control

system pilot bracket will be attached. It should be placed

approximately 2-

" from the rear wall of the burner

pan (see Fig. 5-2).

2. Tap the bracket lightly with a rubber mallet to secure

it in place.

INSTALLATION

Burner

pan

Fuel injector

or air mixer

Valve

Attach the valve to the

air mixer/fuel injector by

rotating the burner pan.

Install shown on

a G4 pan

Fig. 5-1 Install valve

(Design may vary)

Burner pan

Flame

diverter

bracket

/4"

Fig. 5-2 Install diverter bracket (if applicable)

1 2 3 4 5 6 7 8 9 10 ... 13 14

Comments to this Manuals

No comments

R.H. Peterson G4-16P Owner's Manual Page 5

Comments to this Manuals

Related products and manuals for Fireplaces R.H. Peterson G4-16P