R.H. Peterson G4-16P Owner's Manual download pdf (Page 10)

L-A2-102

Rev 8 - 1501081400

Wire bundles go around

the valve and away from

the burner. Coil excess wire

under switch box.

Valve wire

bundle

Pilot

wire

bundle

Switch

box

Valve and heat shield

Burner pan

min

(FIREBOX)

IF SWITCH BOX IS INSIDE FIREBOX; ORIENT ONLY AS

SHOWN BELOW:

(FIREBOX)

BOX ON ITS SIDE

Bottom

min

SWITCH BOX PLACEMENT

Place the switch box outside of the ﬁ rebox and a

minimum of 6" from the burner/ﬂ ame. If the switch

box is in the ﬁ rebox, the switch box must only be

oriented as shown in Fig. 10-1. The switch box must

not be placed in the rear of the ﬁ replace, or in any

other manner than shown in Fig. 10-1. Set the box on

its side and place the bottom of the box toward the

right ﬁ rebox wall (box must be a minimum of 6" from

the burner/ﬂ ame). Be sure that the pilot and valve

wire bundles remain clear of the burner, valve, and

heat shield at all times.

Note: Coil excess wire within the switch box.

CAUTION: THE SWITCH BOX MAY BE HOT

DURING AND AFTER OPERATION.

EPK-1 installation is complete at this point. Ensure

ALL information in this manual is followed to ensure

proper operation.

DECORATIVE MEDIA REPLACEMENT

Refer to the burner instructions for proper placement

of decorative media.

Important: Keep sand, lava granules, and all

foreign objects away from the pilot

assembly, valve assembly, and heat

shield during media placement and at

all times.

INSTALLATION (Cont.)

Remote receiver

(if equipped)

Fig. 10-1Overall Orientation

Remote receiver

(if equipped)

1 2 ... 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

R.H. Peterson G4-16P Owner's Manual Page 10

Comments to this Manuals

Related products and manuals for Fireplaces R.H. Peterson G4-16P