R.H. Peterson G8 series Owner's Manual Page 3

  • Download
  • Add to my manuals
  • Print
  • Page
    / 30
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 2
3
L-F2-066
REV 9 - 1306280800
SPECIFICATIONS AND REQUIREMENTS
WARNING: This appliance is for installation only in a:
1. Solid-fuel-burning masonry or UL-127
factory-built fi replace, or
2. Listed ventless fi rebox enclosure.
It has been designed certifi ed for these installations.
Exception: DO NOT install this appliance in a factory built
replace that includes instructions stating it has not been
tested or should not be used with unvented gas logs.
Note: Installation in any other fi replace is prohibited and
will void any approvals and warranties.
Fireplace Dimensions
Fig. 3-1
The G8 Series vent-free gas log sets are available with
a manual ODS pilot or an on/off remote.
A spark ignition system (piezo) allows the gas pilot to be
lit without the use of matches, and permits the operation
of the appliance during a power outage.
This burner system is equipped with an Oxygen
Depletion Sensor (ODS) safety pilot system. The ODS
senses the amount of oxygen available in the room and
shuts the burner system off before the oxygen level
drops below 18%. The pilot can only be relit when fresh
air is available. This may require opening a window
or a door to another room or cracking the damper
open slightly.
Important: For safe operation and proper performance of this product and to comply with certifi cation, listings,
and building code acceptances, use ONLY Peterson Real-Fyre® controls, parts, and accessories
that have been specifi cally listed or certifi ed for use with this burner system. Use of other controls,
parts, or accessories is prohibited and will void all warranties, certifi cations, listings, and building
code approvals, and may cause property damage, personal injury, and loss of life.
This burner system has been certifi ed to two standards:
UNVENTED ROOM HEATER-ANSI Z21.11.2b-2010
VENTED DECORATIVE APPLIANCE-ANSI Z21.60b-2004
Check local or state codes to determine if vent-free
heaters are permitted in your locality before you install
this burner system as a vent-free appliance. If not
permitted, you may install and operate this burner
system as a vented appliance.
DEPTH
HEIGHT
FR ONT
WIDTH OPENING
Rear
width
Height
Front
width opening
Depth
Page view 2
1 2 3 4 5 6 7 8 ... 29 30

Comments to this Manuals

No comments